Here is where my problem comes into play. I bought the licenses for both after purchasing the table and installed these. and 40's drilled out the size of 60's work well too.). (I also can't get 40amp tips to work, they burn up very quickly, but 60's work very well even at lower amperage settings. (I am also trying to find additional "tools" and tool settings for this setup (I have plasma_short, medium and long) and the correct settings for different guages of sheet. I'm running Mach3 and using Sheetcam to create the GCODE. Anyway, I do have the system working overall pretty well. I would like to find a spot that has good tool settings for my setup though. I do have a recurring problem of the torch occassionally staying too high above the cut and not piercing until I stick a piece of metal in the arc, but most of my settings seem to be working pretty well. I have it down now to the point that I can cut anything that I create in Corel myself and dxfs that I get from some locations. I've run through a ton of problems over the last several months (mostly because I didn't understand what was going on, lol). I have a Plasmaroute 4x8 blaze table with a Thermal Dynamics A60 Cutmaster plasma torch. Hello, first of all, thank you in advance for your help (and for understanding that I'm a newbie who has spent a ton of hours trying to research this and figure it out before asking here).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |